Unsolved
This post is more than 5 years old
4 Posts
0
16034
Changing IP-address on the WSM server - Solved
Changing IP-address on the WSM server - Solved
Hi
I have a customer who has tried to change their ip adress on the WSM/DHCP server.
The server and Clients is in the same network but after the change they get an error message in the PXEboot. PXE-E55: ProxyDHCP service did not reply to request on port 4011.
I was not involved in troubleshooting when they tried this for some time ago so i could not verify if the server did actually listen on that port, etc.
They will try to change the ip adress again and i wonder if sombody has any tips of what could cause this error so we are prepared for it.
Thanks
mhaase-2015
200 Posts
0
June 3rd, 2015 05:00
There's a known issue with WSM installed on a DHCP Server and it is no longer supported.
The port for the DHCP Proxy Service should be set to 67, not 4011.
If the customer has installed WSM on a DHCP Server, they will have to use DHCP Option Tag 66 & 67 to send out the DHCP Option tags to the Clients.
WSM Server can recover from IP Change of the Server automatically.
#Iwork4Dell
Richard.Lian
4 Posts
0
June 3rd, 2015 05:00
Thank you for the answer mhaase.