2 Posts
0
3197
WYSE 5070 SCCM Build BSOD
We are following the guide here.
We have captured the WIM file and are now attempting to deploy the image via SCCM (using a task sequence identical to the guide).
However, during the OS setup phase we are experiencing a BSOD with the CRITICAL_PROCESS_DIED stop error.
We have followed the steps to the letter, so not sure where to go from here.
Any suggestions?
Thanks
James
jameschappy
2 Posts
1
September 18th, 2018 18:00
We ended up capturing a new WIM file. Deploying this new WIM via SCCM completed successfully.
The only thing we changed in the process was leaving the version of the SCCM client that came with the Dell IoT build. Previously we upgraded it to the correct version for our SCCM infrastructure. Don't know if that's what made the difference, but mentioning it in case anyone reading this is clutching at straws.