Winterm S90 won't boot or recognize USB drive
I recently acquired a old Winterm S90 that I want to experiment with. The specifics are:
Wyse Model: SX0
Product id: Winterm S90
Manufactured September 2006
I've been trying to boot the S90 (which does say Windows XP embedded) without luck. It will seem to reach out to the DHCP server and is offered an ip address (according to the OS X Snow Leopard Server server log) but it does not seem to accept it. If the terminal does get to the log in screen it just hangs there. I've tried the Administrator/Administrator default with no luck.
I've also tried to build a USB key using the USB Firmware Tool 188.8.131.52 and firmware file 9S92_S607_512 but in no case does pressing P during the boot sequence cause the system to boot from the USB. I have tried renaming the 92 part of the filename to 90, setting up with or without BIOS/CMOS included, leaving the partition intact, etc. No difference.
I am at a loss for what to try next. Any suggestions?
The S90 does not support the USB firmware tool. You will neeed to use the Wyse Simple Imager toola available at www.wyse.com/downloads under the RETIRED section. Make sure you read the documentation and follow the instructions, as both the S90 and WSI are obsoleted products and no longer supported. The information that is available with WSI was the last one tested.
Visit our Dell Wyse Thin Client Knowledge Base and Manuals web site at www.wyse.com/KB
Visit our Dell Wyse PocketCloud Knowledge Base and Manuals web site at http://pocketcloudsupport.wyse.com/forums
same issues for me...I tried also to look for the Wyse Simple Imager but I cannot find a "RETIRED" section.
Could you please provide me the URL where I can download the needed sw/version?
Thanks a lot in advance and have a nice day!