Unsolved
5 Posts
0
885
XPS 8390, case swap, constant restart
Hello all,
So I've swapped my XPS 8390 from the Dell case to a V200 TG and added a H115i Plat to cool the CPU. After about a minute the system will just restart with no warning. Temps are below 100F and I just have it sitting there idle. Again other than the CPU cooler and case, I'm using all the same components. Any help would be greatly appreciated.
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
July 16th, 2020 12:00
@Sounditout
How did you wire up the front I/O panel? Post some photos if you don't mind sharing. This sounds like another interesting project.
GKDesigns
258 Posts
0
July 16th, 2020 12:00
@Sounditout
Maybe the cooler isn't working... what are the CPU temps C when it reboots?
GK
Sounditout
5 Posts
0
July 16th, 2020 12:00
So for the front IO panel I pulled the power button cable from the old case. I was getting a different set of errors with that from the Dell support program on start up. When i wasn't using it though this is how i had it set up.
I know its a very ugly pic sorry, but this is how i set it up. Again though i pulled the power cable from the old case and i'm using that until i get this restart issue handled.
Sounditout
5 Posts
0
July 16th, 2020 12:00
cpu temp each time is around 28C give or take a degree or two.
Sounditout
5 Posts
0
July 16th, 2020 12:00
Its a little messy at the moment so bear with me please.
Sounditout
5 Posts
0
July 16th, 2020 13:00
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
July 16th, 2020 15:00
@Sounditout
photos are showing up super small
have you had a look at relevant portions of this thread?
XPS 8930 Case Swap
some of the Dell proprietary cabling and I/O panel connections can cause problems