XPS Desktops

Last reply by 01-14-2021 Unsolved
Start a Discussion
2 Bronze
2 Bronze
1047

XPS 8700, how to connect to HDMI?

  • image.jpg

Replies (6)
10 Diamond
1042

Can't tell for sure from your image, but looks like you have an HDMI port on the right end of the video card, that I marked with red arrow, below the bar code label.

The HDMI port in the black panel area on the back is for onboard Intel Graphics. That port can only be used when the first monitor is connected to the add-in video card AND after you enable the Intel Multi-Display option in BIOS setup.

HDMI.jpg

Ron

   Forum Member since 2004
   I'm not a Dell employee

1039

That is micro port I was wondering how to get the onboard graphics to work

1033

As I said, the only way to use the onboard HDMI port is to have at least one monitor connected to any port on the add-in video card and then enable Intel Multi-Display in BIOS, before connecting a monitor to the onboard port.

Do you mean it's a micro-HDMI port on the video card?

You could get a DVI>HDMI adapter. Plug the DVI end into one of the DVI ports on the video card and the HDMI end into the monitor.

Or if that's a micro-HDMI port, get a  micro-HDMI>HDMI adapter.

Keep in mind that these adapters typically work only in one direction. So make sure it's DVI(PC) and HDMI(monitor), or micro-HDMI(PC) and HDMI(monitor).

There are also various different types of DVI, so make sure the adapter matches the port configuration on the video card.

Ron

   Forum Member since 2004
   I'm not a Dell employee

1030

I could you tell me how to enable the intel thung

1028

No point to enabling it unless there's one monitor connected to the video card.

  1. Reboot and start tapping F2 to open BIOS setup
  2. Browse BIOS setup using tab and arrow keys to the Advanced Onboard options
  3. Find Intel Multi-Display and use arrow keys to highlight it and press Enter
  4. Change the setting to Enabled
  5. Save the change and exit BIOS setup
  6. After it boots, power off normally
  7. Connect monitor to that HDMI port
  8. Reboot

Read page 77 and below in the Service Manual for important instructions.

Don't change anything else in BIOS setup except the Multi-Display setting.

Ron

   Forum Member since 2004
   I'm not a Dell employee

1027

Also, if you're trying to use 2 monitors, both probably can be connected to separate ports on the video card so you might not even need the onboard HDMI port.

Onboard Intel Graphics from that HDMI port uses system memory, so that might reduce system performance if total installed RAM is low.

 

Ron

   Forum Member since 2004
   I'm not a Dell employee

Latest Solutions
Top Contributor