Unsolved
This post is more than 5 years old
9 Posts
0
13123
June 14th, 2011 08:00
Network Port Cannot be Accessed
Last night I received this error twice. Where do I start looking for a solution?
o Warning: Member SAN01 network port cannot be reached. Unable to obtain network performance data for the member. Condition already generated an e-mail message. If the condition persists, additional messages will be sent approximately every 6 hours.
No Events found!
MVNOSAN
2 Posts
0
October 13th, 2011 09:00
Got exactly the same problem with a ps6010XV with FW 5.1.1
Have validated that I can ping all eth interfaces and there's no erros registered either on the swicth or the interfaces.
The most annoying part is, that the software doesn't display which port it is.
brgds
Bo
kammer777
7 Posts
0
November 1st, 2011 08:00
Was this from SAN-HQ? If so I have found in my environment that I will sometimes get these if there is a sudden increase in retransmits.
I've also found that unless you get more than three or four an hour you can basically ignore the warning.
Good luck!
-Kammer