scribby

updated

1 month ago

Closed

S

scribby

1 Rookie

•

6 Posts

•

8 Points

0

1252

February 25th, 2023 14:00

Inspiron 16 Plus - 7620 - Fan Noise, Pulse On and Off Constantly

Brand new Dell Laptop 7620 - Inspiron 16 Plus - fan pulses when cool, seems to work normally once warmed up via gpu tests and cpu burn in tests. Temps all appear normal during these so there's no issue with thermal paste. Normal use the laptop returns to this cooler state and starts pulsing again. Running all latest drivers and latest BIOS version. Windows 11.

Dell power manager is set to Quiet mode, power settings in windows set to Passive cooling for battery and AC.

No difference between battery and powered, issue still occurs.

https://youtu.be/v2floEnwPeU

  • scribby

    1 Rookie

    •

    6 Posts

    •

    8 Points

    579

    0

    Posted March 5th, 2023 22:00

    Had a Dell technician attend today, fans and heatsink paste/strips were replaced and now its all running fine, tempreatures are around the same as the previous tests but the fan pulse has finally stopped.

  • scribby

    1 Rookie

    •

    6 Posts

    •

    8 Points

    348

    0

    Posted February 27th, 2023 23:00

    Further testing shows CPU when stress tested maxes out at 94 degrees and GPU when stress tested maxes out around 64 degrees. This constant starting and stopping of the fan is driving me insane. Found a fan monitoring tool that shows me the fan RPM's one is running normally and the other just pulses 0-5000rpm constantly until the system has heated up to the point where its happy to run at a constant speed.

    This seems like a firmware/BIOS issue, I dont believe its windows either as when it starts if I restart the PC it continues to occur even when I enter the setup in the BIOS screen.

  • KORSAP

    1 Rookie

    •

    1 Message

    •

    5 Points

    5

    0

    Posted September 30th, 2026 19:25

    I use the same laptop. The fan noise was incredibly loud; hoping the noise would subside if temperatures dropped, I applied Thermal Grizzly's PTM product, though it took a full 10 days for the temperatures to actually come down. I also performed a mod using Arctic TP3 thermal pads to transfer heat from the heat pipes to the bottom chassis. Since I use the laptop on a stand, the heating of the underside wasn't an issue for me. Average temperatures dropped to 51–52°C, hovering between 68°C and 75°C during gaming. The annoying fan noise used to kick in whenever the temperature exceeded 50°C; it would run for about 30 seconds, stop, and then start up again. I tried almost every software-based solution, but Dell had locked things at the BIOS level, preventing any manual adjustments. Today, as a last resort, I installed an 8.2-ohm, 2-watt resistor on the fan's brown wire. The noise that used to trigger above 50°C is completely gone; the fan only kicks in—very quietly compared to before—when the processor momentarily spikes above 90°C. My Cinebench multi-core score is 8880, and my Geekbench 7 multi-core score is 9650—exactly the same as before the fan modification. I haven't experienced any drop in performance or increase in the temperatures.