Unsolved
This post is more than 5 years old
6 Posts
0
182643
July 2nd, 2013 10:00
Spanning Tree Topology Change Received: MSTID:
Hi guys I have a ten gig switch with two uplink ports in a portchannel and a seperate one as one gig to the same upstream switch. Everything seems to be working fine but i keep getting these log messages in the switch.
<189> Jul 2 10:10:02 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14511 %% Spanning Tree Topology Change Received: MSTID: 0 Po1
<189> Jul 2 10:10:01 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14510 %% Spanning Tree Topology Change Received: MSTID: 0 Te1/0/17
<189> Jul 2 10:09:59 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14509 %% Spanning Tree Topology Change Received: MSTID: 0 Po1
<189> Jul 2 10:09:59 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14508 %% Spanning Tree Topology Change Received: MSTID: 0 Te1/0/17
<189> Jul 2 10:09:34 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14507 %% Spanning Tree Topology Change Received: MSTID: 0 Po1
<189> Jul 2 10:09:33 192.168.0.251-1 TRAPMGR[875730204]: traputil.c(637) 14506 %% Spanning Tree Topology Change Received: MSTID: 0 Te1/0/17
Can someone tell me why I might be getting these messages
DELL-Willy M
802 Posts
1
July 2nd, 2013 10:00
Do you have MST(Multiple Spanning Tree) configured on the uplink device and or this switch? You are seeing that a change topology change ( normally a port coming on or going off) on the subnet 192.168.0.251. It is normal to see these notifications.
If you have an end port where someone is plugging in a device or removing a device you can see this type of response. You can configure the end ports as portfast.
TechKid101
6 Posts
0
July 2nd, 2013 10:00
Both switches have rstp enabled. There should not be any topology change messages as the they are uplink ports which do not shut down. Is this a message that does not have any relevance or is there some kind of stp activity going on that I should be aware of?
DELL-Willy M
802 Posts
0
July 2nd, 2013 11:00
I would not be worried about this message it is sending spanning tree changes about a change on a switch to the other switch. Just general information.
RKRana
1 Message
0
October 19th, 2023 05:09
Hi All,
I am getting frequent spanning tree message -
<189> Oct 19 11:55:53 DELA-8IDFB-ASW04-6 TRAPMGR[dot1s_task]: traputil.c(795) 13230 %% NOTE Spanning Tree Topology Change Received: MSTID: 0 Po4, from 74:86:e2:a6:ae:25