telenoiz
2 Bronze

Re: Data Mover Interconnect and Replication

Hi Avilt,

1. Unmount the filesystem on the destination datamover, then mount it again using the r/w option.

2. For replicator V2, create interconnects for any source/target relationship for which you will want to configure a replication session for. I am not aware of a recommendation based on number of file systems per interconnect. The requirement, I believe, is that the interconnect be defined on both source & target. Defining multiple interconnects for the same source/target pair is not necessary, but if you have multiple interfaces on the same datamover, you could define additional interconnects and distribute your replication traffic. 

3. you can check your interconnect, but the default setting should be 'uses available bandwidth'. That would mean, there is no Celerra bandwidth limiting setting that would affect your throughput.  Your throughput limitations are most likely coming from somewhere else.  Take a look at stats & capacity of the datamover interface used for the replication interconnect.

0 Kudos