SiliconValleyDIY's Posts

SiliconValleyDIY's Posts

Yes, the 2280 slots can hold larger than 1TB. My AW 17 R4 has a Samsung 960 PRO NVMe 2TB as the boot drive. I plan to install two 970 EVO 2TB NVMe 2280s in my next laptop AW 17 R5 that I expect to ... See more...
Yes, the 2280 slots can hold larger than 1TB. My AW 17 R4 has a Samsung 960 PRO NVMe 2TB as the boot drive. I plan to install two 970 EVO 2TB NVMe 2280s in my next laptop AW 17 R5 that I expect to get in the next few weeks.  
Yes it definitely does support Samsung 960 PRO. I am currently running an Alienware 17 R4 with a Samsung 960 PRO 2TB as my boot drive.
My Alienware 17 R4 came with a  Toshiba 1024GB SSD NVMe model THNSN51T02DUK
Problem solved. Spent 3 hours on phone with Alienware Tech Support. Two changes were made and the problem was solved. I do not know which change (or both) actually fixed the problem.  1) rebooted... See more...
Problem solved. Spent 3 hours on phone with Alienware Tech Support. Two changes were made and the problem was solved. I do not know which change (or both) actually fixed the problem.  1) rebooted the computer. Pressed F2 to get into Setup menu. Clicked the Advanced tab. Changed SATA Operation from "RAID on" to AHCI. 2) downloaded and installed the latest Alienware BIOS. Installed BIOS ver 1.1.9 was 1.1.8 After these two changes the Samsung NVM Express driver installation worked just fine. We initialized the new SSD using Disk Management. I wanted to use the new 960 PRO as to boot drive so we Cloned the current boot drive to the 960 PRO. The system now boots faster and my boot drive is 2TB SSD instead of the prior 1TB slower SSD. Conclusion: it is likely that changing the SATA Operation to AHCI was the only change that was needed to fix the Express driver installation, I don't know for sure.
Same here. I just installed a Samsung PRO 960 2TB and I get the same error message when I try to install the NVME driver. One Dell technician said 2TB NVMe would work and another Dell technician ... See more...
Same here. I just installed a Samsung PRO 960 2TB and I get the same error message when I try to install the NVME driver. One Dell technician said 2TB NVMe would work and another Dell technician said the limit was 1TB NVMe. So it is possible that a PRO 2TB may fail to load the driver and a PRO 1TB may load the driver successfully. I don't know yet. The Samsung NVM Express Driver v2.2 Installation Guide says: ================================================= System Requirements The driver supports Windows 7, Windows 8.1 and Windows 10. Recommended system configuration (minimum):  Intel Haswell Refresh Processor  2GB RAM  50MB free disk space  UEFI Bios v2.3 System Configuration Windows Operating System shall successfully load the driver only when Samsung NVMe SSD 960 PRO, 960 EVO or 950 PRO is installed to  PCIe slot directly connected to CPU or  M.2 or PCIe slot connected to PCH. However, in the PCH case, Windows Operating System cannot load the driver under following BIOS configurations where  PCH Storage Configuration is set to “Raid Mode, or NAND/Storage Remapping option*” is enabled. * The option name can be different according to Mother-boards(M/B) manufacturers. Please refer to your M/B manual. =================================================== I will call Alienware tech support later today and see if they can fix this "device is not connected" problem.