Reply to Message

Reply to Message

View discussion in a popup

Replying to:
bluemoon22
1 Copper

RE: PowerConnect 2724 - how to access managed mode

Thanks....so simply stated...connect to any port of the switch having manually configured an IP address of say 192.168.2.2 on my laptop / browse to the switch and then follow:

Figure 6-2. IP Addressing

DHCP — The DHCP client can be enabled to acquire the network configuration dynamically. The

DHCP default value is Disable. This field enables the DHCP client.

IP Address — Specifies the static IP Address currently assigned to the device.

Subnet Mask— Specifies the subnet mask of the static IP Address, currently assigned to the device.

Default Gateway — Specifies the static Default Gateway Address, currently assigned to the device.

DHCP IP Address — Specifies the IP Address received from the DHCP server.

DHCP Mask — Specifies the Subnet Mask received from the DHCP server.

DHCP Default Gateway — Defines the Default Gateway Address received from the DHCP server.

Apply DHCP Address — Activates the IP Address, Subnet Mask Address, and Default Gateway

Address, received from the DHCP server.

Updating Static IP Address

1 Open the IP Addressing page.

2 Verify that the DHCP field is Disable.

3 Manually enter the IP Address, Subnet Mask and Default Gateway fields.

4 Click Apply Changes.

The system Static IP address parameters are applied to the switch.

5 Reconnect the device with the new IP Address.

0 Kudos