Reply to Message

Reply to Message

View discussion in a popup

Replying to:
etaljic81
3 Zinc

Re: Data migration from CX300 to VNX5100 and reconnect LUN Win2003

1. Zone host to the VNX array

2. Register host on the VNX array (restart the Navisphere Agent once you complete step 1 - this should register the host on the VNX)

3. Shut down server

4. Perform a final SANCopy incremental sync (assume you already set up a Incremental SANCopy sync)

5. Add host to the VNX5300 storage group (match the HLU's for the LUNs that were in the CX300 storage group)

6. Power on server

7. Go to disk management and perform a few disk rescans

8. Done. The host will have the same drive letters since the disk signatures were copied over via SANCopy