Reply to Message

Reply to Message

View discussion in a popup

Replying to:
kelleg
4 Ruthenium

Re: VNX5400: cannot connect

Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer. This helps others searching for a similar issue.

glen

PS - point the end of the optical cable at a piece of white paper - you should see a red light. As grw pointed out, you need to use USM to install the new modules. When the array is shipped from the factory it has a fixed configuration and when you powered on the array with the new modules, it will not recognize them. Remove the modules, then run USM to install new hardware and insert the modules when told.

glen