この投稿は5年以上前のものです
3 Apprentice
•
897 メッセージ
1
948
[PowerPath]LUN追加時のPowerPathデバイスのオンラインでの再構成について
以下環境にてVNX上で作成したLUNをOSからオンラインで認識させる場合、PowerPath側ではどのような操作を行えばよいでしょうか。
--------------------------
・OS:Solaris 11.2
・PowerPath 6.0
-------------------------
VNXにてLUNを作成し、ストレーゾグループにLUNをアサインさせた時点で、OSの標準デバイスが作成され、formatで追加したデバイスを
確認することはできました。しかしPowerPathデバイスであるpseudoデバイスについてはこの時点では作成されておりませんでした。
PowerPath Installation and Administration Guide Version 6.0のマニュアルを確認しますと、P68:Reconfiguring PowerPath devices onlineのところに、Powermt config , powermt saveの記載があったのですが、この2つのコマンドのみでよろしかったでしょうか。
※P74 powercf configuration utilityのとこrに、powercf のコマンドの説明もあり、こちらのコマンドの実行も必要なのではと認識しております。
powercf -q
※-qオプション必要?
powermt config
powermt save
なにか情報ありましたら教えてください。
Anonymous
5 Practitioner
5 Practitioner
•
274.2K メッセージ
0
2016年7月5日 18:00
keisさん
VNXにLUNを追加した際のPowerPath側の操作としては、通常、powermt configとpowermt saveの実行のみで良いです。ただし、万が一、見えなかった時にpowercf -qを実行することがあります。(*1)また、Powerpathについて詳しい同僚もpowercfは使ったことがないと言っていました。
*1:ナレッジベース「How do I enable new LUN to be seen by Sun Solaris?(000328590)」
『Solution 1 - Run devfsadm -C. This will re-check the HBAs for connections. This method works most of the time. There is no output from this command. After command runs, run powercf -q, powermt config, and powermt display dev=all to see whether the new LUN shows up. If it does, you are done. If the new LUN does not show up, try the next solution.』
keis3456
3 Apprentice
3 Apprentice
•
897 メッセージ
0
2016年7月5日 18:00
Hiroki K.さん
情報ありがとうございます。
powermt config , powermt save
で実施しているとのこと了解しました。
紹介いただきましたナレッジも参考にいたします。