How To Clean The Dell 7130cdn Laser Printer

How To Clean The Dell 7130cdn Laser Printer

Table of Contents:

  1. Cleaning The Exterior
  2. Cleaning The LEDs

This article provides information on how to clean the Dell 7130cdn Laser Printer

1. Cleaning The Exterior

To remove stains, clean the outside, of the printer using a soft, damp cloth moistened with a mild neutral detergent. Do not spray detergent directly onto the printer.

WARNING: To prevent electric shock, turn the printer off and unplug the power cord from the electrical outlet before cleaning the printer. Use only approved toner vacuum to clean the printer. Do not lubricate the printer with oil.

Back to Top

2. Cleaning The LEDs

Note: Each imaging unit has a cleaning rod located inside its slot

  1. Open the front door

  2. Rotate the lever on the front left side to unlock it

  3. Open the imaging unit cover

  4. Pull the cleaning rod from the lower right corner of the imaging unit slot
  5. Pull out the cleaning rod until it stops, then move it all the way in and out two or three times to clean the LEDs. Repeat this for all four imaging units

    Note: Make sure to pull the cleaning rods out as far as they will go. Push them in as far as they will go. Do not use excessive force

  6. Close the imaging unit cover

  7. Rotate the lever to the right to lock it

  8. Close the front door

Back to Top

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN300190

Last Date Modified: 11/16/2015 09:56 AM

Rate this article

Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.