Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Número del artículo: 000141677

Precision T5810 with AMD W7100 no video on Dual Monitors during boot

Resumen: This article provides information on no video Issue on Dual Monitors during boot on Precision T5810 with AMD W7100

Contenido del artículo

Síntomas

Precision T5810 would not show any video during boot when 2 monitors were connected via DVI and using DP- DVI dongles.

The customer would also get an error message on screen stating "Out of Range signal Cannot display this video mode Change computer display input to 1600x1200 @ 60hz"
 
2 monitors connected were 2007WFP with a maximum resolution of 1600x1200 @ 60 Hz 
 
If 1 monitor was connected, video is shown during boot.
 

 

Causa

 

Resolución

There is a mode, on FirePro graphics cards, called SST - Single Select Timing and on our 14.xxx drivers that is enabled.

When two passive adapters, DP to DVI, are used and identical displays are attached which don't run higher than 1280x1024 res then SST remains enabled and as a result there is no display on boot into Windows. If an active adapter is used alongside a passive adapter then SST is disabled and system boots with Windows displayed correctly.
 
This should be resolved in the new AMD driver 15.201
  

Propiedades del artículo

Producto comprometido

Precision Tower 5810

Fecha de la última publicación

16 ago 2021

Versión

4

Tipo de artículo

Solution

Volver al principio