Refer to the steps below to help resolve the 009-654 / 093-919 / 093-920 / 093-921 / 093-922: YMCK Toner Low Density Errors.
When the C1760nfw/nf/nfw, H625CDW, H825CDW and the S2825CDN Dell Laser Printers are receiving an error 009-654 / 093-919 / 093-920 / 093-921 / 093-922: YMCK Toner Low Density, this may be due to the altitude affecting the toner density inside of the printer during calibration and operation.
As these printers ship with the altitude default set at 0 meters, this amount needs to be adjusted for units at higher altitudes.
After changing this setting, restarting the printer should cause the printer to calibrate and clear the error.
When after adjusting the altitude setting and restarting the printer, the error continues, update the firmware on your printer
For more information, refer to Dell Knowledge Base article Update the Dell Laser Printer Firmware by Downloading and Installing the Latest Version.
When the error persists, you can also use the Clean Developer setting in either the printer Control Panel or from the printer EWS (Figure 2). This setting is available for the Dell C1760nfw/nf/nfw, H625CDW, H825CDW and the S2825CDN Laser Printers.
Figure 2: Clean Developer setting
The Clean Developer setting is intended for the following purposes:
Article ID: SLN304111
Last Date Modified: 08/24/2018 02:44 PM
Thank you for your feedback.