SLES 10 iSCSI timeout after load balancing request when using the native open-iscsi

SLES 10 iSCSI timeout after load balancing request when using the native open-iscsi


This article provides information on what to do if a SUSE Linux Enterprise Server 10 using native open-iSCSI time outs after an iSCSI load balancing request.


Modify the /etc/iscsi/iscsid.conf

To improve this situation, there are two modifications that can be made to the /etc/iscsi/iscsid.conf.

  1. If your discovery is password protected, provide the authentication information to iscsid by adding your password information for the discovery to the end of /etc/iscsid.conf file
    • discovery.sendtargets.auth.authmethod = CHAP
    • discovery.sendtargets.auth.username = <username>
    • discovery.sendtargets.auth.password = <password>
  2. Then add the following 2 new entries to give a little wiggle room with connection timeouts on load balancing activities.
    • node.conn[0].timeo.noop_out_interval = 10
    • node.conn[0].timeo.noop_out_timeout = 30




Article ID: SLN111190

Last Date Modified: 12/22/2014 05:11 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.