Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Article Number: 000138442


Installing Windows 10 on a Precision Workstation Tx600 System Equipped with a single hard drive attached to a PERC H310 RAID Controller

Summary: Precision T7600, T3600 & T5600 hard drive not seen installing Windows 10 on systems with Perc H310 Controller

This article may have been automatically translated. If you have any feedback regarding its quality, please let us know using the form at the bottom of this page.

Article Content


Resolution


This Article has info about Installing Windows 10 on a Precision Workstation Tx600 System Equipped with a single hard drive attached to a PERC H310 RAID Controller.


Installing Windows 10 on a single drive with a PERC H310 RAID Controller

When Windows 10 is installed on a single hard drive in a Precision Workstation Tx600 system equipped with a PERC H310 RAID Controller, Windows 10 will not see the hard drive.


Configure the Single Hard Drive as a RAID 0 Array

You can resolve the by configuring the drive to a single drive RAID 0 array.

This is accomplished by first converting it the physical drive to a RAID disk and then configuring the virtual disk to a RAID 0 array of 1 drive.

Enter the RAID setup by pressing the CTRL + R Hotkey combination at boot.

SLN299153_en_US__1icon NOTE: When working in the RAID BIOS, the keys on the numeric keypad should not be used.

You can do this by following the steps indicated below: (See Figures 1 & 2.)

SLN299153_en_US__21378247952121.RAID-2
Figure 1. - No Hard Drive configured in the RAID Array

SLN299153_en_US__31378247968028.RAID-4
Figure 2. - Selecting the Physical Disk in the RAID Setup.

  • Press the tab key once to highlight the hard drive, press the spacebar once to select the drive (See Figure 3.)

SLN299153_en_US__41378247988232.RAID-5
Figure 3. - Identifying the drives for the RAID Array.

  • Press the tab key 4 times, the OK button should be highlighted, press Enter to finish (See Figure 4.)

SLN299153_en_US__51378248019186.RAID-6
Figure 4. - Selecting the drives for the RAID Array.

  • Press the Enter key with OK highlighted to acknowledge the instruction to initialize the logical drive.(See Figure 5.)

SLN299153_en_US__61378302903686.RAID-7
Figure 5. - Completing the RAID Array configuration.

WARNING: DO NOT INITIALIZE THE DRIVE! This process unlike most in a RAID array does NOT require initialization of the drive in the RAID BIOS. Initialization of the drive will erase all the drive metadata and destroy all data on the drive.
  • Press the ESC key to exit the RAID BIOS, press the arrow key to highlight OK, press the Enter key to confirm the exit. Press CTRL+ALT+DEL key combination to restart the system.

    Start the Windows 10 installation and the drive should be seen.

Reference

Dell PowerEdge RAID Controller (PERC) H310, H710, H710P, and H810 User’s Guide


Article Properties


Affected Product

Precision T3600, Precision T5600, Precision T7600

Last Published Date

10 Apr 2021

Version

3

Article Type

Solution