How to Use and Troubleshoot the XPS One 2710

How to Use and Troubleshoot the XPS One 2710



Article Summary: This article provides information on using and troubleshooting your XPS One 2710.

Table of Contents:

  1. The Computer Fails to Start or There is No Video
  2. Fan and Thermal Problems
  3. XPS One 2710 Specifications
  4. System Board Component Locations
  5. Master I/O Board Component Locations
  6. How to Open the Chassis
  7. How to Remove and Re-insert the Components
  8. Wireless Networking How-to's and Troubleshooting
  9. Dell PC Diagnostics Quick Test and SupportAssist for PCs and Tablets
  10. The Computer Stops Responding
  11. Computer Component is not Recognized
  12. Microsoft Windows Crashes, Stops, Restarts or a Blue Screen Appears

The Computer Fails to Start or There is No Video

If you experience a situation in which the computer does not start at all or if it does turn on (lights turn on and fans are spinning), but the computer does not show any image, listen for a series of beeps during start-up.

  • When beeping codes are heard, refer to (Table 1) to help troubleshoot the issue with your computer.
    Repetitive Beep Codes
    1 Possible motherboard failure - BIOS ROM checksum failure.
    2 No RAM detected.
    If you installed or replaced the memory module, ensure that the memory module is seated properly.
    3 Possible motherboard failure - Chipset error.
    4 RAM read/write failure.
    5 Real Time Clock failure.
    6 Video card or chip failure.
    7 Processor failure.
    Table 1: Repetitive Beep Codes
  • When no beeping codes are heard, perform the following steps:
    1. Disconnect all external peripherals except the keyboardand mouse (for desktop systems). Peripherals also include external storage devices such as flash drives, USB devices, cards etc.
    2. Drain MB power about one minute (until MB lights turn off, which can take from 20 seconds up to one minute).
    3. Remove all the memory sticks (found next to the CPU) and attempt to POST the system using one memory stick at a time on Slot 1. Reinsert all memory sticks, and make sure that their connection to the motherboard is optimal. If after doing this the problem reappears then you may have a defective memory slot on the motherboard.
      • For written information on how to open the back panel and to access the memory modules, browse to the XPS One 2710 Online Manuals. Click the preferred language. Click to view the Owner's Manual. For the Memory Modules, locate the Memory Modules(s) section and follow the instructions.
    4. Clear the CMOS settings:
      For more information on how to open the side panel and location of the clear CMOS jumper connector, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. For information on opening the left side-panel refer to the Left Side-Panel section. For information on the location of the CMOS jumper, locate the Technical Overview section and look in the System-Board Components section for the location of the CMOS jumper.
    5. Perform different video configuration tests: make sure the video card(s) has/have the proper power connections from the power supply, reseat the video card(s) and if more than one video card is present, try them individually.
      • For more information on how to open the side panel and remove and insert the PCI-Express Cards, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. For information on opening the left side-panel refer to the Left Side-Panel section. For information on removing the video card refer to the Graphics Card section.
    6. Remove all but the essential components (one memory module and one Video Card only) including, WiFi adapters, TV tuners, Optical Dives (ODD's), Hard Disk Drives (HDD's) and try to turn the computer on.
      • For more information on how to open the side panel and remove and insert the components, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to each section for instructions on removing that component.
    7. Refer to Dell Knowledge Base article Computer Does Not Turn on, or is Stuck on the Dell Logo Screen.
Back to Top

Fan and Thermal Problems

For information on how to open the back panel and troubleshoot the Cooling Assembly, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to the Working inside your computer section and follow the instructions.

Back to Top

XPS One 2710 Specifications

For information on the XPS One 2710 Specifications, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Specifications (SWF/PDF).

Back to Top

System Board Component Locations

For information on the system board component locations, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to the Working inside your computer section and follow the instructions.

Back to Top

Master I/O Board Component Locations

For information on the master I/O board component locations, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to the Back View section.

Back to Top

How to Open the Chassis

For information on how to open the chassis back panel, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to the Working inside your computer section and follow the instructions.

Back to Top

How to Remove and Re-insert the Components

For information on how to remove and re-insert the components, browse to the XPS One 2710 Online Manuals. Click the preferred language. View the Owner's Manual. Refer to the Working inside your computer section and follow the instructions.

Back to Top

Wireless Networking How-to's and Troubleshooting

For how-to's and troubleshooting information on wireless networking please visit the Dell Networking and Wireless Support Center.

Back to Top

Dell PC Diagnostics Quick Test and SupportAssist for PCs and Tablets

Note: The fastest and easiest way to identify and resolve the problem is by using our quick test online diagnostic tool. This will either fix the problem automatically, or it will guide you through the steps to resolve the problem. If the diagnostic identifies a failing part, depending on the failing part, we will immediately start the process for a free in-warranty replacement part.

Dell provides several options to maintain and diagnose your computer:

  • The Dell PC Diagnostics quick test, can find the most common issues.

  • SupportAssist, previously called My Dell, provides system updates, detects issues and sends you alerts based on your device, which makes solving and preventing problems easier than ever. This application gives you access to everything you need to take the guesswork out of maintaining PCs and tablets. For more information such as how to obtain and install SupportAssist, browse to the SupportAssist for PCs and tablets page.

  • When the computer cannot access the Internet, you can run the built-in diagnostics on your computer, for more information, refer to Dell Knowledge Base article, Run Built-In Diagnostics (ePSA) for Your System.
Back to Top

The Computer Stops Responding

  1. Press the Power button for at least 15 seconds to make sure the computer turns off.
  2. Disconnect all external peripherals including the keyboard, mouse, and external monitor. Peripherals also include external storage devices such as flash drives, USB devices, printers, cards etc.
  3. Press the power button to see if the computer turns on and boots up ok, if not, refer to Dell Knowledge Base article Computer Does Not Turn on, or is Stuck on the Dell Logo Screen.
  4. Download and install SupportAssist. For more information on how to obtain and install SupportAssist, browse to the SupportAssist for PCs and tablets page.
  5. Perform system maintenance on your computer, for more information refer to Dell Knowledge Base article Optimization and Maintenance of Microsoft Windows.
  6. Start attaching devices one at a time and test to see if the computer stops responding.
Back to Top

Computer Component is not Recognized

SupportAssist, previously called My Dell, detects issues and sends you alerts based on your device, This application gives you access to everything you need to take the guesswork out of maintaining PCs and tablets. For more information on how to obtain and install SupportAssist, browse to the SupportAssist for PCs and tablets page.

Back to Top

Microsoft Windows Crashes, Stops, Restarts or a Blue Screen Appears

This link takes you to the Dell Knowledge Base article Microsoft Windows Crashes, Stops, Restarts or a Blue Screen Appears.

Back to Top



Article ID: SLN129740

Last Date Modified: 01/19/2018 09:43 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.