PERC H700/H800 boot virtual disk migration from a different controller is not supported

PERC H700/H800 boot virtual disk migration from a different controller is not supported


Issue

If migrating a boot volume the only supported move is from a PERC H700 to a PERC H700 or from a PERC H800 to a PERC H800. The PERC H700/H800 supports migration of virtual disks created with PERC H200, PERC6 and other PERC H700/H800 controllers for non-bootable virtual disks.

It is possible to migrate a boot volume from a different controller, PERC6 or PERC H200, to a PERC H700/H800 if it will be used to access the data only and not to boot from it. Migrating this volume back to the original PERC6 or PERC H200 is not supported.


In general, do not migrate boot volumes between boot controllers that use different drivers.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificateur de l'article : SLN167341

Date de la dernière modification : 02/03/2015 09:26 AM


Évaluer cet article

Précis
Utile
Facile à comprendre
Cet article était-il utile?
Oui Non
Envoyez-nous votre évaluation
Les commentaires ne peuvent pas contenir ces caractères spéciaux : <>()\
Désolés, notre système d’évaluation n’est pas accessible actuellement. Veuillez réessayer plus tard.

Nous vous remercions pour vos commentaires.