知识库

How Do I Change the Lamp Located Within the Dell 4100MP Projector?




Replace the Lamp On the Dell 4100 Projector

Lamp is approaching the end of its useful life in full power operation. Replacement suggested!

CAUTION: Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper handling, including the touching of the bulb or the lamp glass.

To replace the lamp, perform the following steps:

NOTE:

For information on purchasing replacement parts for your Dell branded projector, navigate to the following Dell website:

"Dell Software and Peripherals"
  1. Turn off the projector and disconnect the power cord.

  2. Let the projector cool for at least 30 minutes.

  3. Loosen the 2 screws that secure the lamp cover, and remove the cover.

  4. Loosen the 3 screws that secure the lamp.

  5. Pull up the lamp by its metal handle.

  6. Reverse steps 1 through 5 to install the new lamp.

  7. Press the Power button.

  8. Using the remote control, press the Menu button.

  9. Using the Four Directional button in the center of the remote, highlight the Management option.

  10. Using the Four Directional button, press the right side of the button to enter the selection.

  11. Using the Four Directional button, highlight the Lamp Reset option.

  12. Using the Four Directional button, press the right side of the button to highlight the Yes option.
    The projector begins to reset the lamp.

NOTE:

The lamp contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance.

www.eiae.org




文章ID: SLN32200

上次修改日期: 05/02/2018 08:52 AM


评价此文章

准确性
有用性
易理解性
这篇文章对您有帮助吗?
向我们发送反馈
注释中不得包含以下特殊字符:<>()\
抱歉,我们的反馈系统目前发生故障。请稍后重试。

感谢您提供反馈。