How to Restore Factory Defaults on Dell Networking Force10 Z9500

How to Restore Factory Defaults on Dell Networking Force10 Z9500



This article explains how to Restore Factory Defaults on Dell Networking Force10 Z9500

Objectives

  1. Important Points to Remember
  2. Command to Restore Factory Default
  3. Examples


Important Points to Remember

  • When you restore all the units in a stack, these units are placed in standalone mode.
  • When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.
  • When you restore the units in standalone mode, the units remain in standalone mode after the restoration.
  • After the restore is complete, the units power cycle immediately.

Command to Restore Factory Default


Warning - Restoring factory defaults will delete the existing persistent settings (configuration, stacking, fanout, etc.) After restoration the unit(s) will be power cycled immediately. Proceed with CAUTION!


Command Parameters
FTOS# restore factory-defaults stack-unit {0-5 | all} {bootvar | clear-all | nvram} Restores and clears config, stacking, fanout, etc..
Bootvar - Reset Boot environment variables
Clear-all - Reset BootVar, NvRam and configurations
NvRam - Reset NvRam



Examples

Example of resetting all stack units:

FTOS#restore factory-defaults stack-unit all nvram
**************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and all persistent settings (stacking, fanout, etc.)*
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution !
***************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
1 Success Success
2 Success Success
3 Not present
4 Not present
5 Not presentPower
Power-cycling the unit(s).



Example of resetting single switch

FTOS#restore factory-defaults stack-unit 1 nvram
*************************************************************
*Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1 Success
Power-cycling the unit(s)






文章ID: HOW10835

上次修改日期: 11/17/2017 12:19 PM


评价此文章

准确性
有用性
易理解性
这篇文章对您有帮助吗?
向我们发送反馈
注释中不得包含以下特殊字符:<>()\
抱歉,我们的反馈系统目前发生故障。请稍后重试。

感谢您提供反馈。