|Article Summary:||This article provides information "How to Clear Non Paper Jam Error Messages on the Dell 2335dn Printer"|
Table of Contents:
|1.||How to Clear Non Paper Jam Error Messages on the Dell 2335dn Printer|
|Display Message||Meaning||Suggested Solutions|
|Close Rear door Rear Door is open. Close Rear Door.||The rear door was opened while duplex printing.||Close the rear door.|
|Data Read Fail Check USB key||Time expired while reading data.||Try again.|
|Data Write Fail Check USB key||Storing to the USB memory key failed.||Check the available USB memory space.|
|Device is not supported||Non USB mass storage device, such as USB mouse, is connected with USB memory port.||Remove the non USB mass storage device from USB memory port.|
|Door Open Close Toner Door||The front cover is not securely latched.||Close the cover until it locks into place.|
|Enter again||You entered an unavailable item.||Enter the correct item again.|
|File Format Not Supported||The selected file format is not supported.||Enter the correct item again.|
|Fuser Door Open / Open Rear Door Close Fuser Door||The fuser door is not securely latched.||Open the rear door and close the fuser door until it locks into place.|
|Fuser Error Fuser Not Installed Check Rear Door||There is a problem in the fuser unit.||Unplug the power cord and plug it back in. If the error is still displayed contact Dell Technical Support.|
|Group Not Available||You have tried to select a group location number where only a single location number can be used, such as when adding locations for a broadcasting operation.||Use a speed dial number or dial the number manually using the number keypad.|
|Hub is not supported||USB hub device is connected with USB memory port.||Remove the USB hub device from USB memory port.|
|In Idle State : [yyy] Empty/Open In Printing State : [yyy] Empty/Open Load [zzz] [xxx]||The paper in the paper tray has ran out.||Load paper in the paper tray.|
|Invalid Cartridge Cartridge is not valid for this machine||The toner cartridge you have installed is not for your printer.||Install a Dell-genuine toner cartridge, designed for your printer.|
|IP Conflict IP address conflict||The network IP address you have set is being used by someone else.||Check the IP address and reset it if necessary|
|Junk Fax Job Cancelled||The received fax number is the number stored in memory as junk fax number.||Change the Junk Fax Setup option.|
|Line Busy The line is already engaged try later||The receiving party did not answer or the line is already engaged.||Try again after a few minutes.|
|Line Error / Check Fax Line||Your printer cannot connect with a remote printer or has lost contact because of a problem with the phone line. OR No dial tone sounds.||Try again. If the problem persists, please wait for an hour or try a different phone line if possible and then try to connect again. |
OR Turn the ECM mode on. Refer to "How to Troubleshoot Fax Issues on the 2335dn Dell Laser Printer"
OR Check that the phone line is connected properly. Refer to "How to Troubleshoot Fax Issues on the 2335dn Dell Laser Printer"
OR Check that the phone socket in the wall is working by plugging in another phone.
|Line Error The Fax Line has a problem. Try again.||The printer has a communication problem.||Ask the sender to try again.|
|Low Heat Error Low Heat Error Power Cycle||There is a problem in the fuser unit.||Unplug the power cord and plug it back in. If the error is still displayed contact Dell Technical Support.|
|LSU Hsync Error LSU Hsync Error Power Cycle||The mail size is larger than the supported size by SMTP server.||Divide your mail or reduce the resolution.|
|Mail Size Error One Page is Too Large||Single page data exceeds the configured mail size.||Reduce the resolution and try again.|
|Memory Full Cancel | Start||The memory is full.||Delete unnecessary documents, retransmit after more memory becomes available.|
|Memory Full Divide the Job||The memory is full.||Split the transmission into more than one operation.|
|Memory Full Fax memory is full. Print received fax job.||The memory is full.||Print received faxes.|
|Memory Full Too many faxes are queued to be sent.||The memory is full.||Cancel reserved fax in the Priority Fax feature.|
|Memory Full Too many faxes are received. Print received fax job.||The memory is full.||Print received faxes.|
|MPF Empty Load [zzz] [xxx] Press Continue||The paper in the MPF has run out.||Load paper in the MPF.|
|Network Error There is a problem with the network||There is a problem with the network.||Contact your network administrator.|
|No Answer The remote fax machine has not answered||The remote fax machine has not answered after several redial attempts.||Try again. Verify the number to ensure that a fax can be received.|
|No Cartridge The toner cartridge is not installed||The toner cartridge is not installed.||Install the toner cartridge.|
|No such job||You are performing an Add/Cancel operation, but there are no jobs waiting.||Check the display to see if there are any scheduled jobs. The display should indicate if any scheduled jobs are in Standby mode, for example, Delay Fax.|
|Over Heat Error Over Heat Error Power Cycle||There is a problem in the fuser unit.||Unplug the power cord and plug it back in. If the error is still displayed contact Dell Technical Support.|
|Power Failure The printer's memory has not been saved.||The power has been turned off and then on and the printer's memory has not been saved.||The printer's memory was not saved due to a power failure. The job will need to be started over.|
|Printer Error Printer Error Power Cycle||A problem has occurred in the Laser Scanning Unit (LSU).|
|Scanner locked / Pull blue latch forward & Press right arrow||The scanner module is locked.||Unlock the scanner and press Cancel.|
|Self Diagnostic||The engine in your printer is checking some problems detected.||Please wait a few minutes.|
|Send Error There is a problem in DNS||There is a problem in DNS.||Configure the DNS setting.|
|Send Error There is a problem in POP3||There is a problem in POP3.||Configure the POP3 setting.|
|Send Error There is a problem in SMTP||There is a problem in SMTP.||Change to the available server.|
|Send Error There is a problem in SMTP authentication||There is a problem in SMTP authentication.||Configure the authentication setting.|
|Send Error There is a problem on the NIC Card||There is a problem on the network interface card.||Configure your network interface card correctly.|
|SMTP Error SMTP Connection has a problem||Connection with the SMPT server failed.||Check that the network cable is connected properly.|
OR Contact your SMPT server administrator.
|Toner Almost Empty Replace Toner||The toner cartridge is empty.||Replace the toner cartridge with a new one.|
|Toner Low||The toner cartridge is almost empty.||Take out the toner cartridge and thoroughly shake it. By doing this, you can temporarily reestablish printing operations.|
OR Replace the toner cartridge with a new one for the best print quality.
|Unusable Device||Non USB device is connected with USB memory port.||Remove the non USB device from USB memory port.|
|Waiting Redial||The machine is waiting for the programmed interval to automatically redial.||Please wait a few minutes.|
|[xxx] indicates the media type.|
[yyy] indicates the tray.
[zzz] indicates the paper size.
Some error messages are provided with graphical images on the LCD of the operator panel.
Click the button below to Tweet feedback or request assistance on anything in the above article.
Article ID: SLN286261
Last Date Modified: 01/03/2014 12:00 AM
Thank you for your feedback.