How to Create an MS-DOS® Boot Diskette
Click on the file name below to download a boot disk creation program:
The File Download window will appear.
Choose to Save this program to disk if it is not already selected and click on the OK button to continue.
The Save As window appears.
Choose a location for the file and click Save.
![]() |
NOTE: | Common locations for internet downloads will be: My Documents, Downloads, or the Desktop. |
When the file download is complete, find the file in its new location and double click the file to begin creating a boot disk.
A gray ZIG-ZAG Hard Disk Recovery window will open. Click on the Setup button.
A black window will appear, advising you that you will need a blank, formatted diskette. Press the <Enter> key on your keyboard.
Place a diskette into drive A: and press the <Enter> key again.
You will be advised that the disk in Drive A is about to be overwritten. To continue, press the <Y> key on your keyboard, followed by the <Enter> key once more.
When the new boot disk is complete, you will be asked to press the <Enter> key for the last time. This will exit out of the command prompt window as well as the ZIG-ZAG Hard Disk Recovery program.
Manually Change the Active Partition
Insert a boot disk into the floppy disk drive.
Start the computer.
The computer boots to a command prompt.
At the C:\> prompt, type the following text:
fdisk
Press the <Enter> key.
You are prompted to Enable large disk support.
Click the Yes button.
Click Set active partition.
Type the number of the partition that you want to make active.
Press the <Enter> key.
Press the <Esc> key.
Remove the boot disk, and restart your computer.
Use the Recovery Console
Refer to the Dell Knowledge Base article below to boot to the recovery console.
"How Do I Boot to the Microsoft® Windows® XP Recovery Console?" Article ID: 150526. |
Type the following text at the C:\> prompt:
cd ..
Press <Enter>
Type the letter of your CD-ROM drive at the C:\> prompt.
Press <Enter>
Type the following text at the prompt:
cd i386
Type the following text at the x:\i386\> prompt, where x is the letter of your CD-ROM drive:
Copy ntldr c:
Press <Enter>
Type Exit and press <Enter> to exit the recovery console.
Reboot your system.
Visite el foro comunitario de Dell para obtener más información
Visite los Foros comunitarios de Dell para averiguar qué opinan otros integrantes de la comunidad de usuarios de Dell. Los foros comunitarios de Dell son el lugar adecuado para que los usuarios de Dell comenten temas relacionados con el soporte técnico, aprendan y se ayuden mutuamente. Utilice los paneles de mensajes para enviar preguntas y respuestas.
Identificación del artículo: SLN130370
Última fecha de modificación: 11/12/2010 00:00
Muchas gracias por sus comentarios.