Automatic Rebuild Fails After Drive Replacement on CERC ATA100/4 Channel RAID Controller - Product Support Quick Note (PSQN) - 133082

Automatic Rebuild Fails After Drive Replacement on CERC ATA100/4 Channel RAID Controller - Product Support Quick Note (PSQN) - 133082




Run the CERC BIOS Configuration Utility, WebBIOS Configuration Utility or Array Manager to manually start the drive rebuild process.

In order to enable the CERC RAID controller’s automatic drive rebuild feature, use the CERC BIOS Configuration Utility or the WebBIOS Configuration Utility to designate one or more hard drives as a hot spare when configuring the array.

If a hard drive fails and a hot spare with sufficient capacity to rebuild the failed drive is not available, follow these steps:

  1. Shut down the system.
  2. Replace the failed drive.
  3. Start up the system.
  4. Run the CERC BIOS Configuration Utility, WebBIOS Configuration Utility or Array Manager to manually start the drive rebuild process.

NOTE: The replacement drive reports Failed until the rebuild is manually initiated.

For more information on setting up hot spares and rebuilding a failed hard drive, see the CERC controller Configuration Software Guide.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID článku: SLN32899

Datum poslední změny: 08/13/2010 12:00 AM


Zhodnoťte tento článek

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
Ano Ne
Zašlete nám svůj názor
Komentáře nesmí obsahovat tyto speciální znaky: <>() \
Je nám líto, ale náš systém zpětné vazby je v současné době mimo provoz. Zkuste to později.

Děkujeme za váš názor.