How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer

How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer


Table of Contents:

  1. How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer

This article provides information on "How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer"


1. How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer

  1. Switch the power off. Open the front the cover.

  2. Pull up on the belt release levers, then rotate the belt up.

  3. With the belt unit at 90° to the front cover, lift the belt on the right side until the peg is clear of the slot. Lift the belt up and to the right to remove.

  4. Unpack a new belt unit. With the belt unit at 90° to the front cover insert the left peg into the mounting hole. Lower the right side peg into the slot.

  5. Lower the belt until it clicks into place.

  6. Remove the protective film cover from the new belt.

  7. Close the front cover.

More info can be found in the 3130cn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



Artikelnummer: SLN286412

Sidste ændringsdato: 08/03/2015 02:05 PM


Bedøm denne artikel

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
Ja Nej
Send os feedback
Kommentarer må ikke indeholde følgende specialtegn: <>()\
Vi beklager, men feedbacksystemet er nede i øjeblikket. Prøv igen senere.

Mange tak for din feedback.