CMC - M1000e LCD Shows "Controller Booting" Message when PS M4110 is Inserted into a Powered On Chassis

CMC - M1000e LCD Shows "Controller Booting" Message when PS M4110 is Inserted into a Powered On Chassis


Article Summary: This article provides information on M1000e LCD Shows "Controller Booting" Message when PS M4110 is Inserted into a Powered On Chassis.



Problem Description

When a PS M4100™ is inserted into the PowerEdge M1000e™ chassis with the chassis power on, the LCD may show “booting“ irrespective of the PS M4100's actual state.
  • The PS M4100 state shows on the LCD if customer navigates to the detail information screen for Storage Array Blades.
  • Only the LCD is affected by this issue.

Instructions (information needed to resolve problem)

Work around: Reboot the Chassis Management Controller (CMC ).

The issue is fixed in future CMC 4.2 and higher firmware.

The current CMC firmware can be found here.





 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID del artículo: SLN285574

Última fecha de modificación: 09/05/2018 05:29 PM


Valorar este artículo

Acertado
Útil
Fácil de entender
¿Le ha resultado útil este artículo?
No
Envíenos sus comentarios
Los comentarios no pueden contener caracteres especiales: <>()\
Lo sentimos. El sistema de envío de comentarios no está operativo en estos momentos. Vuelva a intentarlo más tarde.

Gracias por sus comentarios