Siirry pääsisältöön
Kirjaudu ulos

Tervetuloa Dellin asiakkaaksi

Oma tili
  • Tee tilauksia nopeasti ja helposti
  • Tarkastele tilauksia ja seuraa lähetyksen tilaa
  • Luo tuoteluettelo ja käytä sitä
  • Hallitse Dell EMC-sivustoja, tuotteita ja tuote-tason yhteystietoja yrityksen hallinnan avulla.
Kirjaudu sisään Luo tili Premier-kirjautuminen Kumppaniohjelman sisäänkirjautumissivu
Ota yhteyttä

Artikkelin numero: 000120112

How to configure an IP address on Dell PowerConnect W-IAPs

Yhteenveto: Steps to configure/set up an IP address on a Dell PowerConnect W series IAP (instant access point)

Artikkelin sisältö

Ohjeet

 

This article explains how to configure an IP address on Dell PowerConnect W-IAPs

 


 

Setting an IP address thru DHCP


 

The IAP is set to obtain an IP address thru DHCP by default out of the box.  

In order to receive an IP address thru DHCP follow these steps:

 

1.  Ensure that the DHCP service is enabled on the network.
2.  Connect the ENET 0 port of the IAP to a switch or router using and Ethernet cable.
3.  Connect the IAP to a power source.  This could be thru your POE switch connection or a plug in power adaptor that is purchased separately.

 

The IAP will receive an IP address provided by the DHCP service running thru your switch or router.


 

If there is no DHCP service on the network, the IAP can be assigned a static IP address. If a static IP Is not set, the IAP obtains an IP automatically within the 169.254 subnet.


 

Setting a Static IP


 

In order to set  static IP follow these steps:

 

1.  Connect to a PC or workstation running terminal emulation software (i.e. Putty) to the Console port of the IAP.
2.  Power on the IAP.  An autoboot countdown prompt that allows you to interrupt the normal startup process and access apboot is displayed.
3.  Click Enter before the timer expires.  The IAP goes into the apboot mode.
4.  In the apboot mode, use the following commands to set the IP address:


Hit to stop autoboot:  0

apboot>

apboot> setenv ipaddr 192.0.2.1

apboot> setenv netmask 255.255.255.0

apboot> setenv gatewayip 192.0.2.2

apboot> save

Saving Environment to Flash...

Un-Protected 1 sectors

.done

Erased 1 sectors

Writing

apboot> printenv

 

The printenv displays the configuration that was saved in order to confirm the status.


 

It is highly recommended to use DHCP whenever possible. Setting Static is not a supported option.  If required be sure to set a reservation for the IP in your DHCP server.

 

Artikkelin ominaisuudet

Tuote, johon asia vaikuttaa

W-IAP104/105, W-IAP108/109, W-IAP114/115, W-IAP134/135, W-IAP155/155P, W-IAP175P/AC, W-IAP204/205, W-IAP214/215, W-IAP224/225, W-IAP274/275, W-IAP3WN/P, W-IAP92/93

Edellinen julkaisupäivä

10 huhtik. 2021

Versio

3

Artikkelin tyyppi

How To

Takaisin ylös