Configuring the Adaptec SCSI controller settings to work with tape backup devices. - Technical Tip - 117551

Configuring the Adaptec SCSI controller settings to work with tape backup devices. - Technical Tip - 117551




Configure the Adaptec SCSI controller to work with tape backup devices.

Press <CTRL+A> during the boot process to enter the SCSI BIOS configuration utility. This applies to the Adaptec 7860 or the 7880 controllers, where the tape device is attached. Then select SCSI Disk Utilities and confirm what SCSI ID the unit resides on. Press <ESC> and select Configure/View Host Adapter Settings. Then follow these steps:

1. Press the <F6> key to restore the defaults.

2. Under additional options, choose SCSI device configuration. Then alter the Max Synch Transfer Rate for the SCSI ID of the tape unit and the CD-ROM. Set the level to as low as possible.

3. On the same page, for Send Start Unit Command set the value for NO for the tape device and the CD-ROM.

4. Then press <ESC> and save the changes.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikkelin tunnus: SLN36822

Muokattu viimeksi: 08/25/2010 12:00 AM


Arvostele tämä artikkeli

Tarkka
Hyödyllinen
Helppo hahmottaa
Oliko tästä artikkelista hyötyä?
Kyllä Ei
Lähetä meille palautetta
Kommenteissa ei voi olla seuraavia erikoismerkkejä: <>()\
Pahoittelumme, palautejärjestelmä ei ole nyt käytettävissä. Yritä myöhemmin uudelleen.

Kiitos palautteestasi.