H700 - I2C cannot find idle bus

H700 - I2C cannot find idle bus


Issue:

Battery shown in state failed by monitoring software. OpenManage Server Administrator CLI shows battery state = failed / battery status = critical. RAID controller log of PERC H700 shows several of the following lines:

Solution:

I2C messages in the controller log refer to internal communication (to iDRAC for example) on the SMbus. These messages can be ignored.

Additional Information:

I2C 1 reset

I2C 1 cannot find idle bus!

I2C b PID 1 TIMEOUT!

I2C 1 reset

H700 RAID Controller Log

I2C messages in the controller log refer to internal communication (to iDRAC for example) on the SMbus. These messages can be ignored.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID articolo: SLN164039

Data ultima modifica: 07/19/2013 12:00 AM


Valuta questo articolo

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
No
Inviaci un feedback
I commenti non possono contenere i seguenti caratteri speciali: <>() \
Spiacenti, il sistema di feedback al momento non è attivo. Riprova più tardi.

Grazie per il tuo feedback.