Configuring iDRAC vFlash as a VMware ESXi VMKernel coredump collector

Configuring iDRAC vFlash as a VMware ESXi VMKernel coredump collector


This Dell Technical wiki is written by Amit Sharma and Krishnaprasad K from Dell Hypervisor Engineering team.

When VMware ESXi PSODs (Purple Screen), we require core dump from the failing system to analyze the failure. During a purple diagnostic screen, VMware ESX/ESXi attempts to write a VMkernel coredump to a previously-configured VMKCore (partition type 0xFC) partition on disk and/or to the ESXi Dump Collector service via the network.

This paper talks about utilizing an iDRAC vFlash USB partition for configuring it as a core dump collector. The intended audiences for this whitepaper are those who make use of VMware ESXi core dump partition to collect coredump for analyzing different failures. This paper is basically for people who plan to use a different storage (other than ESXi booted device or underlying storage) for creating core dump partition. It details about the steps to configure an iDRAC vFlash as a VMware ESXi core dump collector.


Related Articles

Configuring iDRAC vFlash as a VMware ESXi VMKernel Coredump Collector
latest revision over 5 years ago by Kong Yang





記事ID: SLN311994

最終更新日: 07/31/2019 01:50 PM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。