ナレッジベース

Configuring Do Not Allow Cluster Network Communication on This Network on iSCSI networks



Article Summary: This article provides information on best practices for Hyper-V clusters using iSCSI - configuring Do Not Allow Cluster Network Communication on This Network on iSCSI networks


Solution:

It is recommended to select Do no allow cluster network communication on this network on the iSCSI NIC's of a Hyper-V failover cluster server. Follow the steps in the solution to achieve this goal.

1. Open the Windows Failover Cluster Manager by opening Server Manager, click on Tools and click Failover Cluster Manager.

2. Choose Networks and expand the tree by clicking the arrow next to Networks.

3. Right-click on the the iSCSI-1 network and select Properties.



4. Ensure Do not allow cluster network communication on this network is selected.

5. Click OK to save the settings.

6. Repeat steps 3 through 5 on any remaining iSCSI networks.

Additional Information:

Additional information about best practices for Hyper-V failover clustering can be found on TechNet.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN289398

最終更新日: 08/27/2014 08:52 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。