How to Restore Factory Defaults on Dell Networking Force10 S4810

How to Restore Factory Defaults on Dell Networking Force10 S4810




This article explains how to Restore Factory Defaults on Dell Networking Force10 S4810.


Important Points to Remember

  • When you restore all the units in a stack, these units are placed in standalone mode.
  • When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.
  • When you restore the units in standalone mode, the units remain in standalone mode after the restoration.
  • After the restore is complete, the units power cycle immediately.


Command to Restore Factory Default

Restoring factory defaults will delete the existing persistent settings (configuration, stacking, fanout, etc.) After restoration the unit(s) will be power cycled immediately. Proceed with CAUTION !

Command

Parameters

FTOS# restore factory-defaults {0-5 | all} {bootvar | clear-all | nvram}

Restores and clears config, stacking, fanout, etc..
0-5 - indicates the switch number to be factory reset
all - indicates all switches to be factory reset
Bootvar - Reset Boot environment variables
Clear-all - Reset BootVar, NvRam and configurations
NvRam - Reset NvRam


Need more help?
Find additional PowerEdge and PowerVault articles

Visit and ask for support in our Communities

Create an online support Request






記事ID: HOW10777

最終更新日: 06/14/2018 10:09 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。