Information about internal SD modules in 11G and 12G PowerEdge servers

Information about internal SD modules in 11G and 12G PowerEdge servers



Article Summary: This article contains information about ESXi and SD card limitations

Issue:

PowerEdge servers may experience inconsistent results when attempting to install the ESXi hypervisor on SD cards in the internal SD module. It is possible to use larger capacity SD cards in the SD modules. There are instances where only 2 GB SD cards are supported.

Symptoms seen when using larger than 2 GB SD cards may include:
  1. Able to install the hypervisor in default mode, but mirror mode fails
  2. SD cards not being recognized during the install of the hypervisor
  3. Intermittently recognizing SD cards in excess of 2 GB

Additional Information:

Refer to the user's guide for the specific platform. IDSDM modules only support up to 2 GB SD cards and limited to installing ESXi hypervisor.

It is not necessary to replace hardware when experiencing problems installing any operating system other than ESXi, or using SD-cards larger than 2 GB.


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN248782

最終更新日: 07/23/2015 02:29 PM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。