ナレッジベース

Dell Management Plug-in for VMware vSphere (DMPVV) version 1.0.1 The number of license only shows 10 hosts from Admin Portal


How to troubleshoot when the number of licenses only shows 10 hosts from Admin Portal when more than 10 licenses where purchased in Dell Management Plug-in for VMware 1.0.1

This is a known issue in the Dell Management Plug-in for VMware vSphere version 1.0.1. This solution is only applied to customers who have license allowed for 50 or unlimited number of hosts.

  1. Go to the Quick Installation Guide, page 18.
  2. Use the Admin Portal to upload the license file "Dell_Management_Center_license.bin".
  3. Change the license number from 10 to 50 or unlimited license.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN163673

最終更新日: 04/03/2017 04:37 PM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。