Precision Rack 7910 Workstation – Error UEFI0067 after post

Precision Rack 7910 Workstation – Error UEFI0067 after post




Customers may report that they are seeing the error UEFI0067 Messaage A PCIe link training failure is observed in arg1 and device link is disabled towards the end of POST in Precision R7910 Rack Mounted Workstation.

This issue is seen due to loose contact between the network / video cards in the PCI slots primarily because they are seated incorrectly.



No Hardware Replacement is required.

Flashing the BIOS without the PCI cards in the slot will resolve the error.

Troubleshooting Steps:
  1. Shutdown the System.
  2. Remove all the PCI Cards from the slots.
  3. Restart the system and Flash the BIOS.
  4. Replace the cards in the respective slots.

For more information, refer to SLN295913 : Precision R7910 Rack Mounted Workstation : A Visual Guide

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN302720

Última fecha de modificación: 08/11/2016 04:27 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.