How Do I Change the Lamp Located Within the Dell 4100MP Projector?

How Do I Change the Lamp Located Within the Dell 4100MP Projector?




Replace the Lamp On the Dell 4100 Projector

Lamp is approaching the end of its useful life in full power operation. Replacement suggested!

CAUTION: Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper handling, including the touching of the bulb or the lamp glass.

To replace the lamp, perform the following steps:

NOTE:

For information on purchasing replacement parts for your Dell branded projector, navigate to the following Dell website:

"Dell Software and Peripherals"
  1. Turn off the projector and disconnect the power cord.

  2. Let the projector cool for at least 30 minutes.

  3. Loosen the 2 screws that secure the lamp cover, and remove the cover.

  4. Loosen the 3 screws that secure the lamp.

  5. Pull up the lamp by its metal handle.

  6. Reverse steps 1 through 5 to install the new lamp.

  7. Press the Power button.

  8. Using the remote control, press the Menu button.

  9. Using the Four Directional button in the center of the remote, highlight the Management option.

  10. Using the Four Directional button, press the right side of the button to enter the selection.

  11. Using the Four Directional button, highlight the Lamp Reset option.

  12. Using the Four Directional button, press the right side of the button to highlight the Yes option.
    The projector begins to reset the lamp.

NOTE:

The lamp contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance.

www.eiae.org




문서 ID: SLN32200

최종 수정일: 05/02/2018 08:52 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

피드백을 보내주셔서 감사합니다.