RACRESET causes iDRAC and Chassis Management Controller (CMC) IP Address to change or re-order when using DHCP.

RACRESET causes iDRAC and Chassis Management Controller (CMC) IP Address to change or re-order when using DHCP.


Article Summary: This article provides information about expected behavior when using DHCP on iDRAC and CMC devices.


When executing a RACRESET command (RACADM RACRESET), the IP Address of the iDRAC and/or CMC may change when configured to use Dynamic Host Control Protocal (DHCP). Integrated Dell™ Remote Access Controller (iDRAC) accepts whatever Ip Address is provided by the DHCP server. It does not remember the old IP Address that was configured.

This normal behavior for the standard DHCP protocol. Similar behavior would occur for NICs configured with DHCP within Linux or Windows operating systems.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

문서 ID: SLN165193

최종 수정일: 01/16/2015 04:00 PM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

피드백을 보내주셔서 감사합니다.