Precision Rack 7910 Workstation – Error UEFI0067 after post

Precision Rack 7910 Workstation – Error UEFI0067 after post




Customers may report that they are seeing the error UEFI0067 Messaage A PCIe link training failure is observed in arg1 and device link is disabled towards the end of POST in Precision R7910 Rack Mounted Workstation.

This issue is seen due to loose contact between the network / video cards in the PCI slots primarily because they are seated incorrectly.



No Hardware Replacement is required.

Flashing the BIOS without the PCI cards in the slot will resolve the error.

Troubleshooting Steps:
  1. Shutdown the System.
  2. Remove all the PCI Cards from the slots.
  3. Restart the system and Flash the BIOS.
  4. Replace the cards in the respective slots.

For more information, refer to SLN295913 : Precision R7910 Rack Mounted Workstation : A Visual Guide

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

문서 ID: SLN302720

최종 수정일: 08/11/2016 04:27 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

피드백을 보내주셔서 감사합니다.