The Precision T3600/T5600 Workstation may experience a No BOOT issue after the hard drive or SATA Cable is replaced for other issues. Follow the guidelines provided in this article to resolve the issue.
The Precision T3600/T5600 Workstations may encounter a No BOOT issue after replacement of the Boot Hard Drive or the Boot Hard Drive SATA cable.
This issue often occurs when the SATA cable is not connected to the correct port on the motherboard.
Ensure the hard drive is connected to the Blue SATA connector marked HDD0 (Figure 1):
Figure 1: Connect the hard drive to the blue SATA connector marked HDD0
If you need further assistance troubleshooting this issue, please contact Dell Technical Support.
Dato sist endret: 03/05/2018 09:33 AM
Takk for tilbakemeldingen.