Verify that the iscsi.conf file has been edited or that the sample file included on the MD3000i ResourceCD has been copied to the /etc/ directory.
(For Linux®)
Review and note any kernel messages (/var/log/messages) for any errors that may be related to this issue. (For Linux®)
If the iSCSI service still fails to start, contact Dell Technical Support.
If this does not resolve the issue, try going through the top section again.
Note:
If these steps do not resolve the issue, please, contact Dell Technical support..
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.
Article ID: SLN156049
Last Date Modified: 03/24/2017 03:14 PM
Rate this article
Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.
Thank you for your feedback.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\