MegaCLI Commands to Pull Controller Logs from the LSI 9265-8i and the LSI 9260-8i RAID Controllers

MegaCLI Commands to Pull Controller Logs from the LSI 9265-8i and the LSI 9260-8i RAID Controllers


Article Summary: This article provides information on MegaCLI commands to pull controller logs from the LSI 9265-8i and the LSI 9260-8i.



Question

What are the MegaCLI™ commands to pull controller logs from the LSI 9265-8i™ and the LSI 9260-8i™?



Answer

The Dell™ DSET Utility does not support PowerEdge™ C-Series servers. Install the MegaCLI from http://www.lsi.com. Below are the most common commands.

Megacli adpeventlog getevents aall > getevents.txt

megacli fwtermlog dsply aall > fwtermlogdsply.txt

MegaCli -LdPdInfo -aALL > c:\logs\ldpdinfo.txt

MegaCli -CfgDsply -aALL > c:\logs\cfgdsply.txt

MegaCli -PdList -a0 > c:\logs\pdlist.txt

MegaCli -AdpAllInfo -aALL > c:\logs\adpallinfo.txt

Megacli -encinfo -aall > encinfo.txt

Support Tools for LSI 9260-8i for Cloudedge Servers

Dell PowerEdge C Server System Management


 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identyfikator artykułu: SLN289672

Data ostatniej modyfikacji: 01/14/2014 12:00 AM


Oceń ten artykuł

Trafne
Przydatne
Łatwe do zrozumienia
Czy ten artykuł był przydatny?
Tak Nie
Wyślij nam swoją opinię
Komentarze nie mogą zawierać znaków specjalnych: <>()\
Niestety, nasz system przekazywania opinii jest obecnie niedostępny. Spróbuj ponownie później.

Dziękujemy za uwagi.