Why am I unable to access devices attached to my QLogic HBA when my primary path has a failure and the system has been rebooted? - KB Article - 164445

Why am I unable to access devices attached to my QLogic HBA when my primary path has a failure and the system has been rebooted? - KB Article - 164445




Why am I unable to access devices attached to my QLogic HBA when my primary path has a failure and the system has been rebooted?

QLDirect will not find devices on the failover path if no devices are detected on the primary controller during boot.

QLDirect is a runtime failover driver, not a boot time driver. QLDirect loads after the disk driver has already loaded and the scan on the bus has occurred. If the primary controller is offline, either by failure or if the cable has been pulled, the controller will not be able to find any drives.

NOTE:If the primary path is unavailable due to a failed HBA, the failover path can be designated as the primary path within QLCONFIG.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identyfikator artykułu: SLN32372

Data ostatniej modyfikacji: 08/01/2010 12:00 AM


Oceń ten artykuł

Trafne
Przydatne
Łatwe do zrozumienia
Czy ten artykuł był przydatny?
Tak Nie
Wyślij nam swoją opinię
Komentarze nie mogą zawierać znaków specjalnych: <>()\
Niestety, nasz system przekazywania opinii jest obecnie niedostępny. Spróbuj ponownie później.

Dziękujemy za uwagi.