Charging and Turning on the Dell XPS 12 9250 Tablet

Charging and Turning on the Dell XPS 12 9250 Tablet

Note: Because the battery may have discharged during shipping, it may be necessary to charge the battery before starting up the tablet.

The USB-C connector on the XPS 12 9250 Tablet can support data transfer or AC power but not both at the same time. When it is connected to a USB port on a computer, it automatically switches to data transfer mode and will not charge the battery. To charge the device, always use the AC power adapter with the USB-to-USB-C cable supplied with the device. The USB-C connector is located on the left-hand side.

LED status What it means
Solid White The battery is charging.
Solid Amber The battery is at low level with the tablet on or in a connected standby state - the screen is off but the tablet is still turned on.
Off The battery is not charging or the battery is fully charged.
Flashing Amber The battery is at a critical level and does not have enough charge to power on. If the power button is pressed during this state, the LED will turn on for 3 seconds and then turn off. Continue charging the tablet.

Normally, the battery will require about 4 hours to fully charge. The charge status can be checked from within the operating system.

NOTE: For more information on the using and troubleshooting the XPS12, refer to the XPS 12 Manuals Page.

To turn the tablet on, hold the tablet horizontal with the webcam at the top, then press and hold the power button located on the right-hand edge close to the top for three to five seconds.
Caution: Charge the battery in an ambient temperature of 0 degrees Celsius (32 degrees Fahrenheit) to 35 degrees Celsius (95 degrees Fahrenheit). Use only the power adapter provided for charging the tablet. Using other power adapters or micro-USB cables may cause damage to your tablet.

Код статьи: SLN300267

Дата последнего изменения: 11/23/2015 02:12 PM

Оцените эту статью

Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.