Kunskapsbank

How to Troubleshoot Regi Jam (Exit Sensor On JAM) on a S2810dn Dell Laser Printer



Table of Contents:

  1. Troubleshoot Regi Jam (Exit Sensor On JAM)

This article provides information on "How to Troubleshoot Regi Jam (Exit Sensor On JAM) on a S2810dn Dell Laser Printer"


1. Troubleshoot Regi Jam (Exit Sensor On JAM)

Step Action Yes No
1 Ensure that the drum cartridge is installed correctly.
Does this solve your problem?
The task is complete. Go to action 2.
2 Replace the drum cartridge. See "Replacing the Drum Cartridge."
Does this solve your problem?
The task is complete. Go to action 3.
3 Ensure that the fusing unit is set properly.
Does this solve your problem?
The task is complete. Go to action 4.
4 Replace the fusing unit, the transfer unit, and the retard roller.
  1. Replace the fusing unit, the transfer unit, and the retard roller.
    See "Replacing the Fusing Unit, the Transfer Unit, and the Retard Roller."
  2. After you replace the fusing unit, Launch the Tool Box.
  3. Click Chart Print on the Diagnosis tab.
  4. Click Pitch Configuration Chart.
    The Pitch Configuration Chart is printed.
The task is complete. Please contact Dell Technical Support.

More info can be found in the S2810dn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



Artikel-ID: SLN298568

Senast ändrad: 08/03/2017 10:38 AM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Kommentarer får inte innehålla följande specialtecken: <>()\
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack för dina synpunkter.