Precision T3600 or T5600 No BOOT after HDD or SATA Cable replacement

Precision T3600 or T5600 No BOOT after HDD or SATA Cable replacement





The Precision T3600/T5600 Workstation may experience a No BOOT issue after the hard drive or SATA Cable is replaced for other issues. Follow the guidelines provided in this article to resolve the issue.


No BOOT after drive or cable replacement.

The Precision T3600/T5600 Workstations may encounter a No BOOT issue after replacement of the Boot Hard Drive or the Boot Hard Drive SATA cable.


Ensure cable properly connected.

This issue often occurs when the SATA cable is not connected to the correct port on the motherboard.

Ensure the hard drive is connected to the Blue SATA connector marked HDD0 (Figure 1):

Figure 1: Connect the hard drive to the blue SATA connector marked HDD0

NOTE: This does not apply to RAID configurations or systems with expansion HDD controllers.

If you need further assistance troubleshooting this issue, please contact Dell Technical Support.




Artikel-ID: SLN301313

Senast ändrad: 03/05/2018 09:33 AM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Kommentarer får inte innehålla följande specialtecken: <>()\
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack för dina synpunkter.