Preskočiť na hlavný obsah
  • Zadávajte objednávky rýchlo a jednoducho
  • Pozrite si svoje objednávky a sledujte priebeh doručenia
  • Vytvorte si zoznam svojich produktov a majte ho vždy poruke
  • Spravujte svoje lokality Dell EMC, produkty a kontaktné informácie na úrovni produktov pomocou Správy informácií o spoločnosti.

Číslo článku: 000179436


DRAC - How to set FAN Speed Offset Values in iDRAC7 Without Reboot

Zhrnutie: How to set the fan speed on Dell PowerEdge servers without restarting the system by using IPMI commands.

Je možné, že tento článok bol preložený automaticky. Ak máte nejaké pripomienky ku kvalite prekladu, pošlite nám ich prostredníctvom formulára naspodku stránky.

Obsah článku


Symptómy

This article provides information on how to set FAN Speed Offset values in iDRAC7 without reboot.


Question:


12th Generation PowerEdge  servers provide support to set FAN speed offset values to provide higher or lower airflow based on hardware configurations.

Currently this is possible by setting values in DRAC configuration utility accessed during POST.   Modifying these setting is not possible through RACADM or GUI at this moment.

Workaround can be used to set these values remotely.
 
 


Answer


FAN speed Offset settings could be modified using ipmitool command.   This will be supported feature in next racadm release for iDRAC7. 
 
Install Dell BMC tools on a management station and ensure IPMI over LAN is enabled in iDRAC Network Configuration. (Click here for Dell BMC Utility download.)

To set value to Low FAN speed offset run command:
 
   ipmitool -I lanplus -H ipaddress of idrac -U username -P password raw 0x30 0xCE 0x00 0x09 0x07 0x00 0x00 0x00 0x07 0x00 0x02 0x02 0x02 0x00 0x00

 
To set value to high FAN speed offset run command:

   ipmitool -I lanplus -H ipaddress of idrac -U username -P password raw 0x30 0xCE 0x00 0x09 0x07 0x00 0x00 0x00 0x07 0x00 0x02 0x02 0x02 0x01 0x00


FAN speed would change immediately after running the command successfully.  
 


Príčina

Not Applicable

Riešenie

Not Applicable

Vlastnosti článku


Dotknutý produkt

Servers

Dátum posledného zverejnenia

27 mar 2024

Verzia

5

Typ článku

Solution