How to route VLAN 1 on PowerConnect 62xx series switches

How to route VLAN 1 on PowerConnect 62xx series switches


Routing the Management VLAN is not allowed on the PowerConnect 62xx series. This article explains how to move management from the default VLAN (VLAN 1) so that the so that the default VLAN can be routed.

1. Verify current Management VLAN and IP address.

PC62xx-LabNet#show ip int
Management Interface:
IP Address..................................... 10.180.58.209
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.180.58.1
Burned In MAC Address.......................... 0019.B99E.6AA3
Network Configuration Protocol Current......... None
Management VLAN ID............................. 1

2. Remove IP address from Management VLAN and create new Management VLAN number.

PC62xx-LabNet#config
PC62xx-LabNet(config)#no ip address
PC62xx-LabNet(config)#vlan database
PC62xx-LabNet(config-vlan)#vlan 99
PC62xx-LabNet(config)#ip address vlan 99
PC62xx-LabNet(config)#end
PC62xx-LabNet#show ip int
Management Interface:
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
Burned In MAC Address.......................... 0019.B99E.6AA3
Network Configuration Protocol Current......... None
Management VLAN ID............................. 99

3. Add IP address to vlan1 and enable routing.

PC62xx-LabNet(config)#interface vlan 1
PC62xx-LabNet(config-if-vlan1)#ip address 10.180.58.209 /24
PC62xx-LabNet(config-if-vlan1)#routing
PC62xx-LabNet(config-if-vlan1)#end
PC62xx-LabNet#show ip int
Management Interface:
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0
Burned In MAC Address.......................... 0019.B99E.6AA3
Network Configuration Protocol Current......... None
Management VLAN ID............................. 99

Routing Interfaces:
Netdir Multi
Interface State IP Address IP Mask Bcast CastFwd
---------- ----- --------------- --------------- -------- --------
vlan 1 Down 10.180.58.209 255.255.255.0 Disable Disable

Note: A host has to be in the VLAN for the state to come up.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

文章 ID: SLN285593

上次修改日期: 07/17/2014 07:48 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
評語中不得包含下列特殊字元:<>()\
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您的寶貴意見。