База знаний

Removing the Fuser Unit on a Dell 5350dn Laser Printer

Article Summary: This article provides information on "Removing the Fuser Unit on a Dell 5350dn Laser Printer".

Table of Contents:
  1. Removing the Fuser Unit on a Dell 5350dn Laser Printer


Removing the Fuser Unit on a Dell 5350dn Laser Printer

To remove the Fuser Unit from the 5350dn Laser Printer for replacement, please follow the guide below:

1. on the top of the 5350dn Printer, please identify the Fuser Wiper cover

2. Squeeze the tab and lift top remove the fuser wiper cover

3. Turn the Printer and open the rear cover

4. with the door open, Identify the fuser door cord on the right hand side

5. turn the cord 90 degrees and remove through the slot (as shown below)

6. with the cord removed and the rear fuser door open, remove the door entirely by lifting from the bottom hinges

7. Identify the two clips on left and right hand side of the internal fuser door and open

8. with the internal fuser door open, identify the clips and push them inwards (they should remain locked in place)

9. use the handle in the centre of the fuser and pull the fuser unit towards you and out of the printer

10. The fuser should now be removed

11. Reverse the process to reinstall the Fuser Unit

If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

Back to Top


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN284189

Дата последнего изменения: 03/22/2016 03:33 PM

Оцените эту статью

Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.